TERRA HS004 HOUSE AMPLIFIER gain 34-44 dB, 121 dBμV
Product description The splitband amplifiers HS004, HS004L are intended for amplifying cable TV, terrestrial TV and FM radio signals. There is a possibility to adjust the gain and slope of the amplifier separately in VHF and UHF bands. The amplifiers can provide power (+12 V) to external equipment through RF IN connector (1). The UHF sub-band of the HS004L amplifier has integrated 30 dB LTE signal suppression filter . The housing of amplifiers meets more stringent screening requirements according to EN50083-2, class A. The amplifiers are intended for indoor use only. Safety instructions Installation of the amplifier must be done according IEC60728-11 and national safety standards. The amplifier is powered from mains 230 V~. This voltage is dangerous to life. Any repairs must be done by a qualified personnel. Do not remove the cover of the power supply section, without disconnecting the unit from the mains supply. Do not plug the amplifier into the mains supply if the power cord or plug is damaged. Do not plug the amplifier into the mains supply until all cables have been connected correctly. To disconnect the amplifier from the mains completely, disconnect plug from the mains socket. The mains socket must be easily accessible. The amplifier shall not be exposed to dripping or splashing water and no objects filled with liquids, such as vases, shall be placed on it. Avoid placing amplifier next to central heating components, near highly combustible materials and in areas of high humidity. No naked flame sources, such as lighted candles, should be placed on amplifier. If the amplifier has been kept in cold conditions for a long time, keep it in a warm room no less than 2 hours before plugging into the mains. Do not insert any objects into ventilation openings; The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains. Mount the amplifier on not flammable wall or in not flammable installation box in vertical position with RF input connector underneath. The amplifier must be fixed with steel screws Ø 4-5 mm. The screws are not included in a package. From top, front and bottom of installed amplifier must be at least 10 cm free space.